EN
6
Operating manual – fan heater TFC 13 E / TFC 14 E
Setting the heating level
Info
Choose the smaller power stage e.g. for a smaller
room. Should it turn out to be insufficient, switch to the
higher level.
1. Set the function selector switch (2) to
I
.
ð
The operating light (1) is illuminated.
ð
The device operates at heating level 1.
2. In order to achieve the maximum heating performance, set
the function selector switch (2) to position
II
.
ð
The device operates at heating level 2.
Cold air operation
If you want to use the device as fan, set the function selector
switch (2) to the fan stage
.
Shutdown
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
•
Turn the function selector switch (2) to the
position
(ventilation only).
•
Keep the fan running for 3 minutes before switching the
device off.
•
Switch the device off by setting the function selector
switch (2) to the
0
position.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Allow the device to cool down completely.
•
Clean the device according to the Maintenance chapter.
•
Store the device according to the Storage chapter.
Errors and faults
Warning of electrical voltage
Tasks which require the housing to be opened
must only be carried out by authorised specialist
companies or by Trotec.
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
The device does not start:
•
Check the power connection.
•
Check the power cable and mains plug for damages.
•
Check the on-site fusing.
•
The motor might be defective. Have a defective motor
replaced by a specialist electrical company.
•
Check whether the device is standing upright and on level
ground. The tilt protection may have been tripped owing to
the fact that the device was knocked over. Always put up
the device in an upright position on a suitable, sufficiently
dimensioned surface.
•
The overheating protection may have been tripped. Have a
specialist electrical company or Trotec check the electrics
and replace the overheating protection.
•
Wait for 10 minutes before restarting the device. If the
device is not starting, have the electrics checked by a
specialist company or by Trotec.
The device is switched on, the fan is operating, the heating
is not:
•
Check whether a heating level is selected.
•
Check whether the overheating protection has tripped, see
chapter Safety.
•
The heating resistor might have blown. Have a defective
heating resistor replaced by a specialist electrical
company.
The fan is not running:
•
Check whether the device is switched on.
•
Check the power connection.
•
Check the power cable and mains plug for damages.
•
The fan motor might be defective. Have a defective fan
motor replaced by a specialist electrical company.
The air current is reduced:
•
Check the air inlet and outlet. Make sure that air inlet and
outlet are not obstructed. Remove any dirt. Observe the
minimum distance from walls or other objects according to
the technical data.
The device is loud or vibrates:
•
Check whether the device is set up in a stable and upright
position.
Summary of Contents for TFC 13 E
Page 11: ......
