6
EN
deep well pump TDP 370 E / TDP 750 E
Information about the device
Device description
The device
TDP 370 E
/
TDP 750 E
is particularly well suited for
pumping clear water from greater depths, e.g. from wells or
shafts.
The device is able to pump up to
5100
l per hour from a
working depth of up to
20
metres. In doing so, the device
reaches a delivery head of up to
40
metres (
TDP 370 E
) or
50
metres (
TDP 750 E
).
The water temperature must not exceed
35
°C.
Info
The illustrations in these instructions feature the device
TDP 370 E
by way of example. The represented
operating steps and explanations also apply to device
TDP 750 E
unless otherwise mentioned.
Device depiction
1
2
4
5
6
3
No.
Designation
1
Connection for pressure line with
1 ¼"
internal thread
2
Pump motor
3
Spacer foot
4
Dirt strainer
5
Suspension eye
6
Power cable
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
Before
transporting the device, observe the following:
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Do not use the power cable to drag the device.
•
Do not carry the device by holding it at the power cable or
hose.
Storage
When the device is not being used, observe the following
storage conditions:
•
dry and protected from frost and heat
•
in an upright position where it is protected from dust and
direct sunlight
•
with a cover to protect it from invasive dust, if necessary
•
Check whether there is residual water left in the device,
and drain any residual water to prevent rust formation.
•
Put the protective cap on the pressure connection to
protect the inside of the device against dust and dirt.
If you do not use the device for an extended period of time, it
must be cleaned thoroughly after its last application and before
recommissioning. Deposits and residues could lead to start-up
difficulties.
For restart, please proceed according to the Start-up chapter.
Assembly and installation
Scope of delivery
•
1 x Deep well pump
•
1 x Spacer foot
•
2 x Mounting screws (spacer foot)
•
1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.