EN
5
convector TCH 1500 E
Information about the device
Device description
The device is used to generate warm air for interior spaces.
The device generates heat by means of an electric heating
element. The air surrounding the heating element is heated. The
heated air rises through the air outlet and thus enters the room.
The device is equipped with an integrated temperature sensor
which controls the heating level depending on the current and
the desired room temperature.
Via the control panel you can set a target temperature value
between 5 °C and 35 °C.
Operation of the device is possible either via the control panel at
the device or via the supplied infrared remote control.
Device depiction
1
2
3
4
5
6
7
8
No.
Designation
1
Air outlet
2
Control panel
3
Display
4
Power cable holder
5
On/off switch
6
Compartment for the remote control
7
Foot
8
Remote control
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
Before
transporting the device, observe the following:
•
Switch the device off.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Do not use the power cable to drag the device.
•
Allow the device to cool down sufficiently.
Storage
Before
storing the device, proceed as follows:
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Allow the device to cool down sufficiently.
When the device is not being used, observe the following
storage conditions:
•
dry and protected from frost and heat
•
in an upright position where it is protected from dust and
direct sunlight
•
with a cover to protect it from invasive dust, if necessary
•
Place no further devices or objects on top of the device to
prevent it from being damaged.
•
Remove batteries from the remote control.
Assembly and installation
Scope of delivery
•
1 x Convector
•
1 x Remote control
•
1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
