12
EN
cordless tacker PTNS 10-3,6V
2. Put the tacker guide nose (4) down on the respective spot
you want to tack. The tacker guide nose must be pushed in
by a few millimetres.
3. Pull the trigger (2).
2
4
ð
The wire nail or staple is injected into the workpiece.
4. Having driven the staple or wire nail in all the way, release
the trigger and withdraw the tacker guide nose from the
workpiece.
5. Set the on/off switch (6) to
0
to switch the device off.
6
Shutdown
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable of
the charger out of the mains socket.
•
Clean the device according to the Maintenance chapter.
•
Store the device according to the Transport and storage
chapter.
Errors and faults
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
Troubleshooting tasks which require the housing to be opened
must only be carried out by an authorized specialist electrical
company or by Trotec.
Light smoke or odour is emitted during the first use:
•
This is not a fault. These phenomena disappear after a
brief runtime.
The device does not start:
•
The battery power might be too low. Recharge the battery.
•
Check the charger and charging socket for dirt. Remove
any dirt.
•
Check whether the charger is connected. If the charger is
connected, the device will not start.
Info
Wait for at least 10 minutes before switching the
device back on.
The battery does not charge:
•
Check whether the device is correctly connected to the
charger and whether the charger is correctly connected to
the power supply.
•
Check the power connection.
•
Check the power cable and mains plug for damages.
•
Check the fuse (home).
•
Check the charger for damages. Should the charger be
damaged, stop using it. Contact the Trotec customer
service.
•
Check the charger connection for dirt. Remove any dirt.
•
The battery might be defective. Contact the Trotec
customer service.
A wire nail or staple is jammed in the device:
Warning
Make sure that the battery has been removed from the
device!
Make sure not to hold the device by the trigger when a
staple or wire nail is jammed inside!
The trigger could be actuated by accident while
removing a jammed staple or wire nail.
•
Open the magazine release and remove the wire nail or
staple.