16
EN
cordless sabre saw PRCS 10-20V
•
Check the quick charger for damages. Should the quick
charger be damaged, stop using it. Contact the Trotec
customer service.
•
Check the battery terminals for dirt. Remove any dirt.
•
The battery might be defective and have to be replaced.
Only use batteries of the same type.
The device does not start:
•
The battery power might be too low. Recharge the battery.
•
Check whether the battery is correctly connected to the
device.
Slide the battery onto the device in a way that the battery
terminals engage. The battery must lock in place in the
device.
•
Check the battery terminals for dirt. Remove any dirt.
Info
Wait for at least 10 minutes before switching the
device back on.
The saw blade is loose:
•
Make sure that the saw blade is firmly locked in place in
the designated recesses of the quick-release chuck.
•
Make sure that the quick-release chuck is locked.
The saw blade experiences difficulties penetrating the
material to be processed or the sawing performance is
insufficient:
•
Check the stroke rate; it must be suitable for both the saw
blade and the material.
•
If the saw blade is worn, replace it with a new one.
•
Check whether the chosen saw blade is suitable for the
material to be processed.
The device becomes hot:
•
Make sure not to exert too much pressure on the device
during sawing.
•
Select a lower stroke rate by applying less pressure on the
on/off switch.
•
Check whether the chosen saw blade is suitable for the
task to be carried out.
•
Keep the venting slots clear to prevent the motor from
overheating.
Note
Wait for at least 3 minutes after maintenance and
repair work. Only then switch the device back on.
Your device still does not operate correctly after these
checks?
Please contact the customer service. If necessary, bring the
device to an authorized specialist electrical company or to
Trotec for repair.
Maintenance
Activities required before starting maintenance
Warning of electrical voltage
Do not touch the mains plug or the battery with wet or
damp hands.
•
Switch off the device.
•
Allow the device to cool down completely.
•
Remove the battery from the device.
Warning of electrical voltage
Maintenance tasks which require the housing to be
opened must only be carried out by authorised
specialist companies or by Trotec.
Notes on maintenance
Inside the device, there are no parts that need to be maintained
or lubricated by the user.
Cleaning
The device should be cleaned before and after each use.
Note
The device does not have to be lubricated after
cleaning.
Warning of electrical voltage
There is a risk of a short-circuit due to liquids
penetrating the housing!
Do not immerse the device and the accessories in
water. Make sure that no water or other liquids can
enter the housing.
•
Clean the device with a soft, damp and lint-free cloth.
Make sure that no moisture enters the housing. Protect
electrical components from moisture. Do not use any
aggressive cleaning agents such as cleaning sprays,
solvents, alcohol-based or abrasive cleaners to dampen
the cloth.
•
Dry the device with a soft, lint-free cloth.
•
Dry the saw blades with a soft, lint-free cloth.
•
Keep the connecting terminals on the device and charger
clean.
•
Remove any dust deposits and, if applicable, wood chips
or material residues from the quick-release chuck.
•
Keep the ventilation openings free from dust deposits to
prevent overheating of the motor.