EN
13
170W multi-function tool PMTS 01-230V
Using a flexible shaft
Note
Never actuate the spindle lock (
3
) button while the tool
is running! This may damage the tool.
Info
Use the flexible shaft for tasks requiring fine and
precise guidance of the tool.
ü
There is no tool in the tool holder (
27
).
ü
The 3.2 mm collet chuck (
14
) is mounted.
1. Unscrew the union nut (
28
) on the tool by turning the nut in
counter-clockwise direction.
28
2. Slightly pull the inner axis (
30
) from the union nut (
31
) of
the flexible shaft.
3. Clamp the inner axis (
30
) into the tool holder (
27
) by
proceeding as described in the chapter "Tool change.
4. Slide the union nut (
31
) of the flexible shaft over the tool
holder (
27
) and tighten it in clockwise direction.
31
30
Proceed as follows to clamp a tool on the handle (
34
) of the
flexible shaft:
1. In order to block the spindle at the handle (
34
), insert the
locking wrench (
16
) into the spindle lock (
33
).
2. Slowly turn the tool holder (
27
) to the locking point until
the locking wrench (
16
) fully engages with the lock and
fixes it.
3. Loosen the clamping nut (
35
) by means of the wrench (
22
)
by turning it in counter-clockwise direction.
33
35
16
34
4. Remove the tool from the tool holder (
27
), if any.
5. Insert the tool required into the tool holder (
27
).
6. Tighten the clamping nut (
35
) in clockwise direction using
the wrench (
22
).
7. Remove the locking wrench (
16
) from the spindle lock (
33
).
8. Check the tool for tight fit.
Warning of hot surface
Ensure that the flexible shaft does not form a loop or
become kinked during operation. There is a risk of the
shaft becoming hot and melting with the hose.
Do not touch the handle if it became hot. Risk of burns.
Using the positioning fixture
Info
The positioning fixture (
25
) allows for exact, vertical
milling of a groove maintaining a defined depth setting
at the same time. Furthermore, the positioning fixture
enables working with a lateral limit stop.
1. Unscrew the union nut (
28
) on the tool by turning the nut in
counter-clockwise direction.
