EN
11
radiant heater IRS 2110
Setting the timer
The timer allows you to program an automatic switch-off time in
increments of 30/60/90 minutes at any heating level.
Automatic switch-off
ü
The device is switched on.
1. Press the timer button (
11
) for several times to adjust the
number of hours of the timer.
ð
The 30 minutes LED (
10
), the 60 minutes LED (
9
) or
the 90 minutes LED (
8
) is illuminated.
ð
The timer has been programmed and the device will
switch off after the predefined time.
Notes regarding automatic switch-off:
•
Manually switching the device off disables the automatic
switch-off function.
Note
All settings can also be made via the remote control.
You can also switch the LED elements (
2
) on and off
via the remote control by pressing the
Light
button (
17
).
Shutdown
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
•
Switch the device off by setting the mains switch (
6
) to
position
0
.
•
Allow the device to cool down completely.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Clean the device according to the Maintenance chapter.
•
Store the device according to the Transport and storage
chapter.
Errors and faults
Warning of electrical voltage
Tasks which require the device to be opened must
only be carried out by authorised specialist
companies or by Trotec.
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
The device does not start:
•
Check the power connection.
•
Check the power cable and mains plug for damage. If you
notice damages, do not try to take the device back into
operation.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
•
Check the on-site fusing.
•
Wait for 10 minutes before restarting the device. If the
device is not starting, have the electrics checked by a
specialist company or by Trotec.
The device does not emit heat:
•
The heating element may be defective. If the heating
element is defective, have it replaced by a specialist
electrical company.
•
Check the mains switch (
6
). If the switch is set to the
0
position, the device is switched off. Switch the device on. If
the mains switch (
6
) is set to position
I
, check whether the
device is in standby mode.
RCD or another fuse trips:
•
Check the fuse. Switch off any other devices to reduce the
load on the line.
•
Contact a specialist electrical company.
The device slightly vibrates during switch-on and then
stops vibrating:
•
Slight vibrations during switch-on are a normal process.
No measures are required.
