EN
4
Operating manual – radiant heater IR 2500 S
Transport and storage
Notice
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
Before
transporting the device, observe the following:
•
Switch the device off.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Do not use the power cable to drag the device.
•
Allow the device to cool down sufficiently.
Storage
Before
storing the device, proceed as follows:
•
Allow the device to cool down sufficiently.
When the device is not being used, observe the following
storage conditions:
•
dry and protected from frost and heat
•
in an upright position where it is protected from dust and
direct sunlight
•
with a cover to protect it from invasive dust if necessary
•
Place no further devices or objects on top of the device to
prevent it from being damaged.
Assembly and installation
Scope of delivery
•
1 x Device
•
4 x Mounting bracket
•
2 x Wing nut
•
2 x Screw
•
4 x Washer
•
4 x Fastening screw
•
4 x Wall plug
•
1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Assembly
The device is suited for wall and ceiling mounting. Alternatively,
you can also use a telescopic tripod. Observe the following
requirement for installation inside a room:
Warning
Risk of fire due to improper installation!
There is a risk of fire if the required minimum
distances are not observed.
The device must be positioned at a distance of at least
180 cm from the floor, at least 90 cm from walls and
other objects such as curtains or sockets, and at least
70 cm from the ceiling.
Mounting the wall / ceiling holder
ü
Use tools suitable for the intended task.
1. Connect two mounting brackets each using a screw, wing
nut and washers.
