4
Operating manual – Oil heater IDE 20 / IDE 30 / IDE 50 / IDE 60 / IDE 80
EN
Intended use
The oil heater IDE was designed to produce warm air in interior
spaces, halls and outdoor areas.
The device is suited for heating large rooms such as storage
spaces, workshops, construction sites, halls and greenhouses. It
is intended to be used without frequent displacement.
Every application going beyond these terms of use is prohibited!
Improper use
The device must not be positioned or operated in areas
with a high risk of fires or in potentially explosive
atmospheres.
The device must not be operated in rooms with an
insufficient combustion air supply.
A number of spatial and technical conditions have to be
considered for the selection of the oil heater's installation site.
Non-observance may impair the proper functioning of the device
or the accessories or can entail risks of personal injury and
property damage.
The following is to be observed for positioning:
• The device is to be set up in a stable position on
incombustible ground.
• The device is to be installed near a chimney or an outer wall.
• The device must be connected to a properly secured mains
power socket.
• The room where the device is positioned must be sufficiently
ventilated.
• The minimum distance between the wall and the air inlet
opening of the device must be at least 2 m (see figure).
• The minimum distance between the device and combustible
materials must be at least 3 m.
• The inlet and outlet openings must not be covered.
• There must be no walls or large objects near the device.
• There must be a sufficient number of fire extinguishers
available.
• If the device is installed outdoors, it must be positioned under
a roof and protected from rain.
The oil heaters IDE 20 / IDE 30 / IDE 50 / IDE 60 / IDE 80 consist
of the following components:
Oil heater
Intended and improper use
Installation conditions
min. 2 m
Description of the device
No.
Designation
A
air outlet
B
upper cover
C
carry handle
D
chimney connection
E
power cable holder
F
lower cover
G
tank indicator
H
fuel tank cap
I
wheel
J
control panel
K
temperature indicator
L
temperature selection
M
main switch
N
lower tubular frame
O
tank
P
pump
Q
fuel filter
R
fan
