14
EN
particle counter BQ21
Connecting a measuring device
Info
The app can simultaneously be connected to several
different measuring devices or measuring devices of
the same type and also record several measurements
at the same time. The number of the sensors that can
be connected depends on the terminal device.
Proceed as follows to connect a measuring device to the
terminal device:
ü
The Trotec MultiMeasure Mobile app is installed.
ü
The Bluetooth function on your terminal device is activated.
1. Switch on the measuring device (see chapter Operation).
2. Make sure that the Bluetooth function is activated on the
measuring device.
3. Start the Trotec MultiMeasure Mobile app on the terminal
device.
ð
A list of active and available sensors will be displayed.
Sensors
Measurements
Reports
Customers
Available sensors
Active sensors nearby
Sensors
Settings
Connect
4. Press the button to refresh the display or if the desired
measuring device is not displayed.
ð
The terminal device now scans the surroundings for all
active sensors.
Sensors
Measurements
Reports
Customers
Settings
Sensors
Active sensors nearby
Connect
Connect
Connect
Connect
Connect
Connect
Connect
Connect
Connect
5. Select the desired sensor from the list of active sensors.
ð
The measuring device now connects to the terminal
device.
ð
The measured value indication appears on the display.
Measured value indication
After the sensor has been successfully connected to the
terminal device, the submenu for the measurement opens and a
request appears on whether the measurement is to be recorded.
Sensors
Measurements
Reports
Customers
Settings
Recording a
measurement
Do not record
The current measured value and the corresponding unit are
displayed in the measured value field.
After several measurements have been carried out, the lowest
value, highest value, average value and current value are
displayed below the measured value field.
Depending on the setting of the measuring mode on the device,
the measured values are indicated on the display:
•
particle concentration in
Number per litre
(n/l) or
•
mass concentration (µg/m
3
)
You can change the indication by changing the measuring mode
on the device (see chapter Selecting the measuring mode).
After starting the measurement, a continuous measurement (X/T
measurement) is carried out according to the preset
measurement duration. The detected measured values are
indicated in the measurement value display.
The measured values can be displayed numerically or
graphically. By tapping the measured value field, you can switch
between the display modes.
