6
EN
luxmeter BF06WP
Connecting the appSensor
Info
The app can simultaneously be connected to several
different appSensors or appSensors of the same type
and also record several measurements at the same
time.
Proceed as follows to connect the appSensor to the terminal
device:
ü
The Trotec MultiMeasure Mobile app is installed.
ü
The Bluetooth function on your terminal device is activated.
1. Start the Trotec MultiMeasure Mobile app on the terminal
device.
2. Briefly actuate the
On / off / measurement
button (3) three
times to switch on the appSensor.
ð
The LED (2) flashes yellow.
3. Press the
Sensors
button (6) on the terminal device.
ð
The sensors overview opens.
4. Press the
Refresh
button (7).
ð
If the scanning mode was not active before, the colour
of the
Refresh
button (7) will change from grey to black.
The terminal device now scans the surroundings for all
available appSensors.
5. Press the
Connect
button (8) to connect the desired sensor
to the terminal device.
ð
The LED (2) flashes green.
ð
The appSensor is connected to the terminal device and
starts measuring.
ð
The on-screen display changes to the continuous
measurement.
Sensors
BC21WP
BA16WP
BM22WP
BP21WP
BA30WP
SENSORS
MEASUREMENTS
REPORTS
CUSTOMERS
SETTINGS
Connect
Active sensors nearby
Available sensors
8
7
6
BF06WP
No. Designation
Meaning
6
Sensors
button
Opens the sensors overview.
7
Refresh
button
Refreshes the list of sensors near the
terminal device.
8
Connect
button
Connects the displayed sensor to the
terminal device.
Continuous measurement
Info
Note that moving from a cold area to a warm area can
lead to condensation forming on the device's circuit
board. This physical and unavoidable effect can falsify
the measurement. In this case, the app will either
display incorrect measured values or none at all. Wait a
few minutes until the device has become adjusted to
the changed conditions before carrying out a
measurement.
When the appSensor has been successfully connected to the
terminal device, a continuous measurement is started and
indicated. The refresh rate is 1 second. The 12 most recently
measured values are displayed graphically (9) in chronological
sequence. The currently determined and calculated measured
values are displayed numerically (10).
SENSORS
MEASUREMENTS
REPORTS
CUSTOMERS
SETTINGS
9
10
11
BF06WP
Brightness
[3.003 | 4.999] Ø 4.038
No. Designation
Meaning
9
Graphic display
Indicates the illuminance as measured
over the course of time.
10 Numeric display
Indicates the minimum, maximum and
average values for the sound level as
well as the current illuminance value.
11
Menu
button
Opens the menu to adjust the settings
of the current measurement.
Info
The indicated measured values will not be saved
automatically.
Info
By tapping on the graphic display (9) you can switch
over to the numeric display and vice versa.
