EN
9
multimeter BE47
Battery test
Danger
Do not test batteries while they are installed in the
devices. The batteries must be removed before tests
can be carried out.
1. Turn the function switch to 1.5 V or 9 V BAT. Use the
1.5 V position for "AAA", "AA", "C", "D" and other
1.5 V batteries. Use the 9 V position for rectangular
9 V monobloc batteries.
2. Insert the plug of the red measuring line into the V/Ω/mA
measuring socket and the plug of the black measuring line
into the COM measuring socket.
3. Apply the black test probe to the negative side of the
battery. Apply the red test probe to the positive side of the
battery.
ð
The measured value is shown on the display.
Battery type
Good
Low
Poor
1.5 V battery
>1.35 V
1.22 to 1.35 V <1.22 V
9 V battery
>8.2 V
7.2 to 8.2 V
<7.2 V
Maintenance and repair
Battery change
A battery change is required when the battery status indication
flashes or the device can no longer be switched on (see chapter
Inserting the batteries).
Cleaning
Clean the device with a soft, damp and lint-free cloth. Make
sure that no moisture enters the housing. Do not use any
sprays, solvents, alcohol-based cleaning agents or abrasive
cleaners, but only clean water to moisten the cloth.
Repair
Do not modify the device or install any spare parts. For repairs
or device testing, contact the manufacturer.
Errors and faults
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
Display segments are only faintly visible or flicker:
•
The battery voltage is too low. Exchange the batteries
immediately.
The device displays implausible measured values:
•
The battery voltage is too low. Exchange the batteries
immediately.
Disposal
The icon with the crossed-out waste bin on waste
electrical or electronic equipment stipulates that this equipment
must not be disposed of with the household waste at the end of
its life. You will find collection points for free return of waste
electrical and electronic equipment in your vicinity. The
addresses can be obtained from your municipality or local
administration. For further return options provided by us please
refer to our website www.trotec24.com.
The separate collection of waste electrical and electronic
equipment aims to enable the re-use, recycling and other forms
of recovery of waste equipment as well as to prevent negative
effects for the environment and human health caused by the
disposal of hazardous substances potentially contained in the
equipment.
Li-Ion
In the European Union, batteries and accumulators must not be
treated as domestic waste, but must be disposed of
professionally in accordance with Directive 2006/66/EC of the
European Parliament and of the Council of 6 September 2006
on batteries and accumulators. Please dispose of batteries and
accumulators according to the relevant legal requirements.
