10
EN
LED work lamp PWLS 05-10 / PWLS 06-10
Errors and faults
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
Troubleshooting tasks which require the housing to be opened
must only be carried out by an authorized specialist electrical
company or by Trotec.
The battery of the PWLS 06-10 does not charge:
•
Check if the USB charging cable is plugged in properly into
both the charger and the device.
Check if the USB charging cable is properly connected to
both the contacts of the charger and the device
PWLS 06-10
.
•
Check USB charging cable, charger and device
PWLS 06-10
for damages. Do not use the damaged device
anymore if you detect any damages. Contact the Trotec
customer service.
•
Check the fuse (home).
Note
The integrated battery might possibly be defective.
Contact the Trotec customer service.
The device is not lit:
•
The batteries of the PWLS 05-10 may be empty. Replace
them with new batteries.
•
The battery power of the PWLS 06-10 may be too low.
Charge the battery via the USB charging cable and a
charger.
•
On the battery indication (4 blue LEDs) of the PWLS 06-10
you can check whether the battery has been completely
charged.
•
Check the USB charging cable of the PWLS 06-10 for
damage. If the USB charging cable is damaged, stop using
it. Contact the Trotec customer service.
Note
The LEDs are possibly damaged. Contact the Trotec
customer service.
Note
Wait for at least 3 minutes after maintenance and
repair work. Only then switch the device back on.
The device still does not operate correctly after these
checks:
Please contact the customer service. If necessary, bring the
device to an authorised specialist electrical company or to
Trotec for repair.
Maintenance
Activities required before starting maintenance
Warning of electrical voltage
Do not touch the mains plug of the charger with wet or
damp hands.
•
Switch the device off.
•
Hold onto the mains plug while pulling the power cable of
the charger out of the mains socket.
•
Disconnect the USB charging cable.
•
Allow the device to cool down completely.
Warning of electrical voltage
Maintenance tasks which require the housing to be
opened must only be carried out by authorised
specialist companies or by Trotec.
Notes on maintenance
The device does not require maintenance.
Cleaning
The device should be cleaned before and after each use.
Warning of electrical voltage
There is a risk of a short-circuit due to liquids
penetrating the housing!
Do not immerse the device and the accessories in
water. Make sure that no water or other liquids can
enter the housing.
•
Clean the device with a soft, damp and lint-free cloth.
Make sure that no moisture enters the housing. Protect
electrical components from moisture. Do not use any
aggressive cleaning agents such as cleaning sprays,
solvents, alcohol-based or abrasive cleaners to dampen
the cloth.
•
Dry the device with a soft, lint-free cloth.
•
Keep the connecting terminals on the device and charger
clean.
•
When you are currently not charging the battery, leave the
cover (10) on the USB connections. This way, no dirt can
enter.
