EN
9
pyrometer TP7
Switching the continuous measurement function on or off
The device comes with a function for continuous
measurements. If this function is activated, the device
constantly measures the temperature until deactivated.
Please proceed as follows to switch on the continuous
measurement function:
1. Repeatedly press the MODE button (6) until the
corresponding icon in the Indication for continuous
measurement (12) flashes.
ð
The characters OFF appear on the upper measurement
value display (20).
2. Press the Laser button (7) or the Lamp button (5).
ð
The characters ON appear on the upper measurement
value display (20).
3. Press the Measurement button (4) to start a continuous
measurement.
ð
The device starts measuring.
4. Press the Measurement button (4) again to stop the
continuous measurement operation.
ð
The device stops the continuous measurement
operation and indicates the determined measured value.
Setting the upper and lower alarm thresholds
You can set both an upper and lower alarm threshold for the
measured value at the device. Upon exceeding or falling below
this value an acoustic signal will be emitted by the device.
Additionally, the display lights up in one of the following colours:
Display colour
Meaning
Flashes red
Surface temperature exceeds
activated upper threshold. The display
flashes red and a constant alarm tone
is emitted. Also works when the
display illumination is deactivated.
Flashes blue
Surface temperature below activated
lower threshold. The display flashes
blue and a constant alarm tone is
emitted. Also works when the display
illumination is deactivated.
Continuously illuminated
in green
Surface temperature is in normal
range. The display will only be
illuminated in green if the display
illumination is activated.
Please proceed as follows to set the upper and lower alarm
thresholds:
1. Repeatedly press the MODE button (6) until the
corresponding icon flashes in the Indication of the upper
alarm threshold (13) / Indication of the lower alarm
threshold (14).
ð
The characters OFF appear on the upper measurement
value display (20).
2. Press the Laser button (7) or the Lamp button (5).
ð
The characters ON appear on the upper measurement
value display (20).
3. Then press the MODE button (6) again.
ð
The currently saved value for the alarm threshold will be
indicated on the upper measurement value display (20).
4. Use the Laser button (7) or the Lamp button (5) to change
the value for the alarm threshold as desired.
Enabling / disabling the alarm threshold
Please proceed as follows to enable / disable the upper and
lower alarm thresholds:
1. Repeatedly press the MODE button (6) until the
corresponding icon flashes in the Indication of the upper
alarm threshold (13) / Indication of the lower alarm
threshold (14).
ð
The characters OFF appear on the upper measurement
value display (20).
2. Press the Laser button (7) or the Lamp button (5) to
activate the alarm threshold.
ð
The characters ON appear on the upper measurement
value display (20).
ð
The desired alarm threshold is now activated.
3. Press the Laser button (7) or the Lamp button (5) again to
deactivate the alarm threshold.
ð
The characters OFF appear on the upper measurement
value display (20).
ð
The desired alarm threshold is now deactivated.
Maintenance and repair
Battery change
A battery change is required, when a battery indication lights up
on the display (8) or the device can no longer be switched on.
See chapter Operation.
Cleaning
Clean the device with a soft, damp and lint-free cloth. Make
sure that no moisture enters the housing. Do not use any
sprays, solvents, alcohol-based cleaning agents or abrasive
cleaners, but only clean water to moisten the cloth.
Repair
Do not modify the device or install any spare parts. For repairs
or device testing, contact the manufacturer.
