EN
7
sound locator LD6
4. Connect the USB charging cable to the device and / or
headphones (both devices use the Micro USB system).
ð
The battery LED (5) is illuminated in red. The charging
process is completed as soon as the light turns green.
ð
The headphone LED (14) is illuminated in red. The
charging process is completed as soon as the light goes
out.
5. Remove the charging cable when the charging process is
completed.
6. Pull the charger out of the mains socket.
Initial start-up
Prior to initial start-up headphones and device need to be
paired.
1. Press and hold the power button (8) at the device for
approx. 6 to 8 s until the Bluetooth LED (4) begins to flash.
ð
The device is now in pairing mode.
2. Press and hold the
power
button (12) at the headphones
for approx. 7 s until the headphone LED (14) flashes blue
in a rapid interval.
ð
The headphones are now in pairing mode.
3. Hold both devices in the immediate vicinity of one another
until the connection is established.
ð
The Bluetooth LED (4) will be permanently illuminated.
ð
The headphones emit a single brief acoustic
confirmation signal and the headphone LED (14) is
permanently illuminated in blue.
4. First, turn down the volume of the headphones by pressing
the volume button (10, V-).
ð
An acoustic confirmation signal indicates the current
sound level.
Switching the device on
Info
If you have just finished pairing the devices for initial
start-up, both the device and the headphones are
switched on already.
1. Press the power button (8) at the device until the battery
LED (5) is illuminated.
ð
The device is switched on.
ð
The LED bar graph will indicate the sound level after a
few seconds.
Switching the headphones on
Info
If you have just finished pairing the devices for initial
start-up, both the device and the headphones are
switched on already.
1. Press the power button (12) until the headphone LED (14)
lights up in blue. An acoustic confirmation signal is emitted
additionally.
ð
The headphones link up with the device.
ð
If the connection has been established successfully,
there should be audible sounds. Adjust the volume of
the headphones if necessary.
If the connection attempt fails, switch both units off and then
back on in the following order:
•
Device
•
Headphones
If further connection attempts keep failing, delete the current
device pairing of the headphones at the device and start over in
pairing mode. To do so, please proceed as follows:
ü
The device is switched off.
ü
The headphones are switched off.
1. Press and hold the frequency button (6) at the device and
then the power button (8). Keep both buttons pressed
simultaneously.
2. If the Bluetooth LED (4) flashes, let go of the buttons.
3. If all LEDs flash, you can switch the device off.
ð
All pairings are now deleted.
4. Now proceed as described in section Initial start-up.
