6
EN
oil-filled radiator TRH 27 E
Assembly and start-up
Scope of delivery
•
1 x Oil-filled radiator
•
2 x Foot with 2 castors each
•
1 x Cable holder
•
1 x Screw
•
1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Assembly
Mounting the feet
The castors on the feet are already preassembled.
1. Place the device upside down on a scratch-proof, even
surface and in a stable position.
2. Place the left foot upside down on the left side of the
device.
3. Fasten the left foot with a screw.
4. Place the right foot with the slots upside down on the last
two fins on the right side of the device.
5. Close the four clips of the right foot.
I.
II.
6. Turn the device over and set it down on the castors.
ð
Check the feet and castors for tight fit. The feet should
rest evenly on the fins to ensure the upright position of
the device.
