EN
7
Ozone generator Airozon 60000
•
Make sure that no curtains or other objects interfere with
the air flow.
•
Do not position the device near inflammable substances
and gases.
•
Make sure that the air inlet and outlet are not obstructed.
•
Make sure that the device is protected from spray water.
•
Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
•
Make sure that extension cables are completely unrolled.
•
The room temperature should be approx. 5 °C higher than
the usual room temperature.
Connecting the power cable
•
Insert the mains plug into a properly secured mains socket
located outside of the room to be cleaned. This enables
you to switch the device off in case of an emergency
without having to access the room.
Operation
Note
Avoid open doors and windows.
Operating elements
8
9
10
6
6
Timer
8
10
6
8
11
12
14
13
No.
Designation
Description
6
On/off
button
Switching the device on or off
I
: Switching the device on
0
: Switching the device off
Is illuminated when the device
is switched on.
8
Operating hours counter Indicates the operating time
9
Operating control lamp
•
Illuminated when the
device is in operation
•
Emits a beep sound in
intervals
10
Timer
Set treatment duration:
0–100 hours
(ozone generation
begins 1 minute after
activation)
11
Display
Displays the set time of the
timer
12
PROG
button
Selecting the setting mode and
the individual display
indications
13
RESET (+)
button
•
Resetting to start time of
timer
•
(
+
) selection mode =
increase time
14
START/STOP (-)
button
•
Starting and stopping the
timer
•
(
-
) selection mode =
decrease time
Switch-on / switch-off
Warning
Risk of injury caused by ozone!
Exit the room as soon as you have switched the device
on so as to prevent contact with ozone.
Warning
Risk of injury caused by ozone!
The device is not a hermetically sealed system. There
is always the risk of ozone emitting from the device.
If possible, connect the cable of the device to a socket
located outside of the room with the device. In the
event of an emergency, you can pull out the power
cable from the socket without having to enter the
room.
1. Press the
on/off
(6)button to switch the device on.
ð
The operating control lamp (9) is illuminated.
2. Press the
on/off
switch (6) again to switch the device off.
