Chapter 1
Tropos 7320 Router Installation Guide
35
FIGURE 23
Data Port Connection
6.
Connect the cable ends that were routed through the connector access cover to the LAN and
Management ports on the router. Use an appropriate RJ45 8-pin modular plug to terminate
the cables at the desired lengths. The outer jacket and conductive shield must be stripped to
expose the twisted pairs for attachment, as shown in
. The proper location of the
connections on the circuit board is shown in
.
7.
Verify that the protection unit is properly grounded.
trp_112
O-ring
AC power
connector
Cable guides
Grounding bolt
Connector access cover
Tighten six screws to
fasten access cover
