5
Warning
Do Not touch the Flame Guard directly after use, all surfaces will be
HOT! Please allow your flame Guard to completely cool before
handling. Do Not pick up the Flame Guard by the glass pieces.
Rectangular or Square Guard Frame Assembly
NOTE: During assembly, ensure that the Caution imprint on each
pane of glass is facing downward. When fully assembled, the
Caution imprints must face outward.
Before you begin attaching the Glass Panes to the Brackets, take a
moment to partially back out the Set Screws with plastic nibs on all
Brackets. The plastic nibs fit on to the end of the Set Screws and
will protect the Glass Panes from the metal end of the screws.
Foot Bracket with Set Screws Corner Bracket with Set Screws
Place Glass Pane #1 (for rectangular, use long pane) on a prepared
surface. With the Foot Bracket Assembly Screw holes facing
upward, slide one lower corner of the Glass Pane into the slot on
the Flame Guard Foot. Tighten the Set Screw with plastic nib to
secure the Glass Pane to the Foot Bracket.
6
Attach a second Foot Bracket to the remaining lower corner of
Glass Pane #1 using the same method as used for the first Foot
Bracket. See photo below.
Repeat this process for Glass Pane #3 (for rectangular, use long
pane). This will produce two Glass Panes with two Foot Brackets
on each pane: Pane #1 and Pane #3.
Place and hold Glass Pane #1 in a vertical position. The Foot
Bracket Assembly Slots will now be facing upward. Place one lower
corner of the Glass Pane #2 in to one Foot Bracket. Tighten
Assembly Screw. See photo below.
