R9TFIRETABLE
Page 9 of 12
Rev. D11MAR14
LIGHTING INSTRUCTIONS
To light your new Fire Table, complete all installation and safety instructions above. Be sure to
install a 9 volt battery in the ignition system battery case mounted on the inside post of the right
door frame. To install the battery, follow the instructions on page 5.
1. Make sure the gas valve on the gas tank is open (turned all the way to the left).
2. Rotate gas valve knob counter-clockwise (left) to center position.
3. Depress and hold the gas valve knob.
4.
Turn “On” spark igniter by depressing switch in short bursts until pilot lights.
5. Once lit, release switch for spark igniter while continuing to depress valve knob for 20
seconds.
6. Turn knob counter-clockwise (left) to light main burner. NOTE: If fails to light, rotate knob to
center position, wait 5 minutes for gas to clear, repeat Steps 3 ~ 6. If pilot goes out, repeat
Steps 3 ~ 6.
7. Once Fire Table has ignited, DO NOT leave unattended.
FIRE TABLE SHUTDOWN
1.
Turn “off” Fire Table by slightly pressing and turning valve knob clockwise (right) to “OFF”
position.
2.
Turn “off” gas to Fire Table at LP tank or other remote location.
3. Once Fire Table has cooled completely, use appropriate cover (sold separately) to protect
Fire Table.
Spark Igniter
Switch
Gas Valve Knob
