11
Stoneworks
®
Top Attachment
Parts List
(1) Table Top with hardware attached
Step 1
Place Table Top (A) upside down on the prepared work surface.
Remove one Screw and Washer from each Attachment Bracket
(B). Retain Screws and Washers (C)(D).
Step 2
Loosen the 2nd screw on each Attachment Bracket enough to
enable you to rotate the bracket to provide clear access to the
Frame Channel (E).
Step 3
Using two persons, place Table Frame (F) upside down on the
Table Top, matching the Table Top Frame with Frame Channel.
Step 4 (500063SWB, 730563SWB, 730584SWB only)
Place the Center Tube Support over the umbrella ring in the
center of the Table Top Frame.
Step 5
Rotate Attachment Brackets back to secure Table Base Frame to
Top. Replace all Screws and Washers. Make sure the Table Top
is sitting squarely and evenly on the Table Base Frame - then fully
tighten all the screws.
Step 6
Your table should now be fully assembled and ready for two
persons to lift into an upright position.
12
Reserved for future product
