Before putting the resin Vat. into the machine, please make sure the FEP film is tight. If the FEP film is not tight,
please tighten the screw on the bottom of the resin Vat. to fix the FEP film; then follow the steps in the figure below
to install it. Put the resin Vat. back and fasten the buckles on both sides to complete the leveling (as shown in fig.
(9) & (10) .
9
Setup Manual
Click here to change the exposure time.
Fig. (7)
Fig. (9)
Fig. (10)
Fig. (8)
Re-raise the platform, and the level rises about 120mm, click on the touch screen <Return> to Setting
1, click <Next> to enter Settings 2, then click <Exposure> -<Next> to check whether the light
source is working normally, as shown in fig. (7) ; The screen should display the same as the figure below and the
image indicates that the UV lights work perfectly, as shown in fig. (8) ;
