TRONE Aquatina ETBCERN-12.WH, Instruction Manual

Page: 20 / 32

•
You are now ready to adjust the length of time that the
SyphonAssist jet is active. Using the remote press the [
+ -
]
button to increase or decrease the amount. When you hear a
double beep, you have reached the maximum or minimum
setting. Once you have set your desired level press the flush
button on the side knob. Your side knob begins flashing red.
•
You are now ready to adjust the amount of water that fills the
bowl after the flush. Using the remote press the [
+ -
] button to
increase or decrease the amount. When you hear a double
beep, you have reached the maximum or minimum setting.
Once you have set your desired level press the flush button on
the side knob. You have now exited the flushing time
adjustment.
o
Note: Waiting too long without any buttons pressed
in any of these adjustments will cause the toilet to exit
this mode.
PAIRING THE REMOTE
1)
Unplug the other smart bidet toilets nearby (tripping the GFCI
on the plug will also work).
2)
While the remote is on standby mode, press and hold the
Weak [
-
] and Back [ ] buttons at the same time for 3
seconds or more until the light indicators on the front of the
remote start flashing at the same time.
3)
Enter the code mode, then press the Water Temperature
[ ] or Seat Temperature [ ] to adjust the address code.
4)
Make sure to press the Stop button [ ] to save the settings.
Failure to do so after 5 seconds will automatically exit without
saving any changes.
5)
Press and hold the On/Off button [ ]
on the toilet’s side to
turn it on. Once the code is successfully matched, you may
already use the remote to control your smart toilet.