14
ASSEMBLY STEPS
ADJUSTING THE SEAT
The Seat (66) (98-2) of this bike is fully adjustable
both vertically and horizontally.
To adjust the height of the Seat Slider Tube (5),
loosen and pull the Adjusting Knob (Ø52 x 70.5
x M16 x 1.5) (62) outward, then raise or lower the seat
(66) (98-2) to the desired height. Once adjusted, re-
insert and tighten the Adjusting Knob (Ø52 x 70.5
x M16 x 1.5) (62) to secure the Seat (66) (98-2) in
place. To adjust the Seat (66) (98-2) back and forth,
loosen and pull the Adjusting Knob (Ø52 x 70.5 x M16
x 1.5) (62) outward, then slide the Seat (66) (98-2) to
the desired position. Once positioned, re-insert and
tighten the Adjusting Knob (Ø50 x 57 x M10 x 22) (74)
to secure the seat slider tube in place.
ADJUSTING THE HANDLEBAR
It is important that the Handlebar (8) and Seat (66) are both set to the correct height for your body. To
adjust the handlebar height, loosen and pull the Tension Knob (Ø65 x 39 x M10) (63) outward, then slide the
Handlebar Post (4) up or down to the desired height. Once adjusted re-insert and tighten the Tension Knob
(Ø65 x 39 x M10) (63) to secure the handlebar post in place.
ADJUSTING THE BALANCE
In order to achieve a smooth and comfortable ride, you must ensure that the stability of the bike is secured. If
you notice that the bike is unbalanced during use, you should adjust the Foot Levelers (Ø45 x 10 x M10 x 20)
(68) located beneath the Front Stabilisers (6) and Rear Stabilisers (7) of the bike.
To do so, use Allen Wrench (S6) (36) to loosen 2 Nuts by turning them clockwise. With the nut loosened, rotate
the Foot Leveler (Ø45 x 10 x M10 x 20) (68) until it sits level with the surface that the bike is on. When you
have finished adjusting the foot leveler, use Allen Wrench (S6) (36) to re-tighten the 2 Nuts by turning them
counter-clockwise. If required, repeat this process to adjust the remaining Foot Levelers (Ø45 x 10 x M10 x 20)
(68).
EMERGENCY BRAKE
During use, users can stop the bike completely by pushing down on the Tension Knob (Ø65 x 39 x M10) (63).
Pushing down on the Tension Knob (Ø65 x 39 x M10) (63) will enforce the brake and bring the bike to an
immediate stop.
#20M03T011 SPIN1200 USER MANUAL.indd 14
2020/03/25 2:55 PM