Trojan SHAPE 200, Care Instructions And Assembly Manual

Page: 6 / 16

Recheck
all bolts and nuts are
tightened securely
before using the machine
1564-6
ASSEMBLY STEPS
STEP 06
Insert the PEDAL (13 L), PEDAL (14R) to the CRANK ( Mark “L” for the
left side, and mark “R” for the right side)
STEP 04
• Get the Tension Cable (38) out of the Handlebar Tube (40) hole, and
connect it to the Tension Controller (36) as shown in fig A and fig B.
Fig A : Put the Cable (36) end into the spring hook.
Fig B : Pull the knob and force the short Cable (36) into the gap of the
bracket.
• Insert the Tension Knob (36) into the Handlebar Post (25), and attach
with Screw (35). Tension is increased by turning the Tension Knob (36)
clockwise, and decreased by turning the Knob counterclockwise
STEP 05
• Attach the Handlebar (40) to the Upright Post (25) with Screws (55)
and Washers (19).
• Insert the Wires (60) into the bigger hole and pull them out from the
top of the Upright Post (25).
• Open the battery cover on the back of the
computer, and install 2 AA batteries.
• Connect the male end of Sensor Line (54) to the
Computer (39) and connect the Wires (60) on the
Computer (39) respectively. Attach Computer (39)
onto the Upright Post (25).
CAUTION:
Ensure that cables are not
damaged during assembly or
when tightening screws.