Trojan EXECUTIVE 600, Care Instructions And Assembly Manual, Page: 6 / 28

1521-6
4. ASSEMBLY STEPS
Two persons are required to finish the assembly steps.
(Caution!! Please follow the assembly steps below to avoid injury).
STEP 1
• First attach the bottom Control Wire to the Plastic Wire
protection sleeve by pulling the Guide Wire inside the Right
Upright Tube (D). Position it through the round hole on the
side of the right upright tube, then insert both Upright Tubes
(C, D) into the two locations (as shown in the drawing) on
the frame.
• Secure them with Bolts (a) and Wrench provided.
NOTE
In order to prevent any injury, two persons are required to
assemble the product. Please be aware that one person must hold the
upright tubes during the assembly process, to prevent the tubes from
falling.
CAUTION:
Ensure that cables are not damaged during assembly or when
tightening screws.
STEP 2
• Attach the Side Covers (E, F) to the Body Frame, as shown in the
drawing. Tighten them with Bolts (b) provided.
STEP 3
• Pull out the Wires within both Handrails from the
Upper Hole of the Consol with the guide wire in the
Consol Base (A). Attach to Wires in Hand Rails (G,H)
Then insert both handrails (G,H) into the console base
illistrated.
CAUTION:
Ensure that cables are not damaged during assembly or
when tightening screws.