Trojan ELLIPTI-CYCLE 200, Care Instructions And Assembly Manual

Page: 6 / 20

15
14
12
15
1415
14
15
3
12
14
1
15
11
1
11
50
15
62
59A
59B
2
59A 59A
B A
59B
59B
68
6L
2
22L
44
6R
62
44 22L
68
1569-6
4. ASSEMBLY STEP
STEP 01
• Attach the Front Stabilizers (3) to the Main Frame (1) with
the Carriage Bolts (12), Washers (15) and Cap Nuts (14).
• Attach the Rear Stabilizers (76) to the Main Frame (1)
with the Carriage Bolts (12), Washers (15) and Cap Nuts
(14).
STEP 02
• Connect Sensor Cable (50) to the the Extention Cable
(62).
• Insert the Tension Wire (59B) into the Upright Tube (2)
• Secure the Handlebar Post by Screws (11) and
Washers (15).
• Attach Tension Cable (59B) to the Tension Controller
(59A) as shown in figure A and B.
STEP 03
• Attach the end of the Lower Handlebars (6L and 6R) to
the axle on the Upright Tube (2) with the Washers (44)
Nylon Nuts (22L) and Nut Caps (68).
CAUTION:
Ensure that cables are not damaged
during assembly or when tightening screws.