Troglotech T812 Pan & Tilt Camera User Manual Page 6
OPERATION GUIDE
Your T812 camera is supplied with a C-Spanner which is used to separate the
camera into the Camera Head and Rod Adaptor. When used on the T804 Pushrod
system, the camera is always used as a single unit. When fitted on the Troglotech
Tractor System (not yet released), only the Camera Head is required.
If, in normal use, the two assemblies
become loose, they can be mated again
using the spanner as shown here.
The T812 is fitted with a impact-
absorbing buffer to protect the camera.
This is designed to be sacrificial and
will wear down over time.
To ensure that the camera has
continued protection, when the buffer
has been worn it must be replaced as
shown to the right.
There are three recessed Pozi-Drive
screws, remove all three screws to
remove the buffer.
Clean the front of the camera with a
damp cloth before replacing with a new
buffer.
The buffers are available from your
distributor.
