page 14
page 13
Turning ON
Please turn on the COMPUTER SECTION of your Xdream FIRST
by tapping the button that can be found directly inside the circular
hole which is at the front of the bike. You will then notice the
computer booting up on the screen.
Next please turn on the BIKE SECTION of your Xdream
by flicking the switch near the back foot of the bike to 1, ensuring that
nobody/nothing is touching ANY part of the bike when turning the bike on.
Turning OFF
Please turn off the COMPUTER SECTION of your Xdream
by tapping the button inside the circular hole.
Next turn off the bike section of your Xdream
by flicking the switch near the back foot of the bike to 0.
Turning ON/OFF
1
2
1
1
2
2
Setting up the Xdream
The Rider/Pedal Interface
When pedalling, the ideal foot position is to have the ball of the foot directly over the
pedal axle. With the Xdream you can use normal cross-training shoes, or special
‘clip-less’ cycling shoes which have a stiffer mid-sole and Shimano® SPD - compatible
cleats to allow them to fix securely to the pedal.
If you are using lace-up fitness shoes make sure that your laces are safely tucked out
of the way.
Handlebar height
Finally you need to set your handlebar height. This should have the centre handlebar
clamp in line with or above the saddle height. Use the adjuster knob to raise or lower
the X-Bars. Ensure that you don’t extend the handlebar above the ‘max’ marking.
Once you have your saddle and handlebar positions set, make a note of the number
etched on the side of the seat post, the saddle rails and the handlebar stem. Now it
will be easy to set the right position in future.
