14
Operation with the 72760 Signal Controller (Analog Operation)
Limited analog operation is possible with the 72760 (Märklin)
signal controller. To do this, the decoder must be set using
a CS2/CS3 to MM operation (Address 255). Defining Track 1,
the initialization and jumping from particular tracks are not
possible.
The E242325 cable can be used to connect the turntable to
the controller. However, the smaller plug (signal side!) to
it must be cut off. The turntable (ex. with a Central Station)
must be programmed to Address 1 for operation with the
72760 controller (Reprograming with the controller is not
possible!).
Programming the Turntable with the 72760 for Address 1
The programming described here always works regardless
of which address is set at the beginning. The programming
begins about one second after the voltage is turned on.
Turn Button 1 on
turn Button 1 off
Turn Button 2 on
turn Button 2 off
Turn Button 3 on
turn Button 3 off
Turn Button 4 on
turn Button 4 off
With the opposite procedure (Button 4 on, Button 4 off, ...),
the turntable can be set back to address 225.
Define Track 1 itself
1. Run onto desired Track 1
2. Turn off layout („STOP“ on controller)
3. Turn layout back on and within 5 seconds press the
buttons <clear><input><clear>
Note: The turntable accepts no switching commands as
long as the locking feature for the deck is open.
Initializing
When initializing, the turntable rotates a complete circle and
evaluates the spoke tracks. The turntable thus remains only
at actual spoke tracks.
If you change the order of the spoke or blind tracks on the
turntable, the turntable must be initialized again.
The initialization can be started within 5 seconds using the
buttons <end><input><end> after turning the layout on.
Operation with DCC
The 66861 turntable is preset for operation using DCC /
mfx. It can be reprogrammed to MM. This is only possible
however with the Central Station 2 / 3 using mfx. It can also
be reprogrammed back. Reprogramming for operation with
the 72760 control box using DCC
is not
possible.
Summary of Contents for H0 66861
