Read Before Using:
Functions:
Modes:
Cleaning & Maintenance:
Drainage:
Mist & Lights Buttons:
Warning Lights:
How to Clean:
Troubleshooting:
Mode
Instruction
Light condition
Continuous mode
Continuous operation
Power and working light on.
Interval mode
Will alternate between 2 mins of
Power light is on. Working light
running time and 30 seconds of
blinks while in 30 second
resting mode
resting mode.
•
Place the diffuser on a dry and even surface.
• Use only clean water at room temperature to fill the water tank.
• Disconnect the power before performing machine maintenance and cleaning.
• DO NOT use detergents, solvents or abrasive agents to clean the diffuser.
• Use soft cleaning cloth when cleaning mist chip.
• Do not allow water to get into the air outlet.
• Always place the device in an upright position.
• Always keep DC connector dry before connecting.
• Do not wash the tank directly under running water.
• Wipe the mist chip gently.
• Avoid water getting into the air outlet when refilling.
• Always keep the lid between the tank and base dry.
• Keep appliance out of reach of children when in operation.
• Keep device away from heat-emitting devices such as heater, table top
cooker or electric burner.
• Always operate in a well ventilated area.
•
An ultrasonic diffuser emits cool mist.
• Night light/background light comes in 7 colors to choose from.
• Works best with essential oil.
• Can be used as a sterilizer by putting in 10-20 drops of alcohol or vinegar.
• Low power consumption.
• Auto cut-off function when water level runs low.
• Interval mode to operate for longer hours.
Drain the water
from the opening
opposite the air
outlet.
Warning: Don’t
empty water from
the vent hole.
•
Disconnect from the power supply when not in use.
• Always keep the tank dry when not in use.
• Use a damp cloth to clean the exterior. Use a clean swab or cloth to clean
the water tank.
• Empty and rinse the water tank, wipe it dry with a clean cloth every time
when using a different type of essential oil.
Use a damp cloth to clean the exterior.
Use a clean swab or cloth to clean the water tank.
Power supply not connected
Power supply connected/standby mode
Water level is low
Not in operation
Diffuser in operation
30 seconds of rest in interval mode
Pour small amount of clean water into the tank and wipe gently.
Repeat these steps until the tank is cleaned. Avoid water getting into the outlet.
Use a dry soft cleaning cloth to wipe the tank and lid dry.
Put the cover back on and store in a well ventilated place when not in use.
Step
Press
Button
Light
Problems
Reasons
Handling ways
Red light
Off
On
Blinking
Off
On
Blinking
Blue light
Instructions
Instructions
Instructions
Condition
Indicator lamp is displaying
abnormally; no mist emitting.
Power supply not connected properly.
Water below operating level.
Add water, reconnect the power
supply and press “Mist”.
Pour out some water and keep
the water level below max line.
Indicator lamp is normal;
no mist emitting.
The air outlet or the tank
cover is blocked.
Clean the air outlet or
tank cover.
Clean mist chip.
Mist chip is dirty.
Too much water in tank.
Indicator lamp shows water level
low; there is enough water.
Mist is small.
