General Information
82
Cruise Control Adjust Button
The cruise control adjust button is a
two way switch with the top marked
RES/+ and the bottom marked SET/-.
For more information on cruise control
operation, see page
90.
Daytime Running Lights (DRL)
Switch (if equipped)
When the ignition is switched
ON and the daytime running lights
switch is set to DRL mode, the daytime
running lights warning light will
illuminate.
The daytime running lights and low
beam headlights are operated manually
using the DRL switch. Press the top of
the switch for DRL mode, and the
bottom of the switch for low beam
headlight mode.
Warning
Do not ride for longer than necessary
in poor ambient light conditions with
the Daytime Running Lights (DRL) in
use.
Riding with the daytime running lights
when dark, in tunnels or where poor
ambient light is apparent may reduce
the riders vision or blind other road
users.
Blinding other road users or reduced
vision in low ambient light levels may
result in loss of motorcycle control and
an accident.
Note:
• During daylight hours the daytime
running
lights
improve
the
motorcycles visibility to other road
users.
• Low beam headlights must be used
in any other conditions unless the
road conditions allow for high beam
headlights to be used.
MODE Button
When the MODE button is pressed and
released it will activate the Riding Mode
Selection Menu in the display screen.
Further presses of the MODE button will
scroll through the available riding
modes, see Riding Mode Selection on
page
35.
Press and hold the MODE button when
a riding mode is selected provides direct
access
to
the
riding
mode’s
configuration menu.
For more information on riding mode
selection and configuration, see page
44.
Turn Signal Switch
When the turn signal switch is pushed
to the left or right and released, the
corresponding turn signals will flash on
and off. To turn off the turn signals,
push and release the switch in the
central position.
Models Equipped with Automatic
Self-Canceling Turn Signals
A short press and release of the turn
signal switch to the left or right will
cause the corresponding turn signals to
flash on and off three times, then go off.
