5 of 8
Installation of the Alarm Unit
1.
Remove the left and right hand fuel tank infill panels.
Refer to the service manual.
2.
Remove the four fixings and then remove the seat
bridge.
1. Seat bridge
2. Fixings
3.
Locate the black, twelve-pin connector on the main
wiring harness and remove the connector shorting
plug.
1. Black, twelve-pin alarm connector
2. Shorting plug
Note:
•
The alarm connector is an unused black coloured
terminal block and is located on the frame
beneath the seat bridge of the motorcycle. The
shorting plug is the cover for this terminal block
which is fitted with a double hoop of black cable.
•
The shorting plug must be returned to
DATATOOL along with the registration
documentation.
1. Alarm/immobiliser connector
2. Shorting plug
Note:
•
Read the warning notices printed on the cleaning
wipe packet in the fitting kit.
•
The surfaces to which the alarm unit adhesive
pads are affixed must be clean and dry to ensure
that the adhesive has a sound base to adhere to.
Use the cleaning wipe supplied for this purpose.
2
1
4
2
1
Caution
When fitting self-adhesive parts care must be taken to
ensure positioning is correct and accurate. Once the
adhesive has been attached to the mounting surface, there
is no satisfactory method of removal and re-positioning if
incorrectly aligned. Initial bonding is instant, full bonding is
achieved after 72 hours.
cckk
1
2
