Maintenance and Adjustment
111
Caution
Continued
Covering the headlight lens during
operation with items of clothing,
luggage, adhesive tape, devices
intended to alter or adjust the
headlight beam or non genuine
headlight lens covers will cause the
headlight lens to overheat and distort,
causing irreparable damage to the
headlight assembly.
Damage caused by overheating is
not considered a manufacturing
defect and will not be covered under
warranty.
If the headlight must be covered
during use - such as taping of
the headlight lens required during
closed-course conditions - the
headlight must be disconnected.
Headlight
Caution
The use of non-approved headlight
units may result in damage to the
headlight unit and/or motorcycle.
Use a genuine Triumph supplied
headlight unit as specified in the
Triumph Parts Catalog.
Always have replacement headlight
units installed by an authorized
Triumph dealer.
The headlight unit is a sealed,
maintenance free LED unit. The
headlight unit must be replaced in the
event of the failure of the headlight.
Headlight Adjustment
1
1. Headlight assembly mounting bolt
To adjust the headlight beam:
• Always make sure the handlebars
are in the straight ahead position.
• Vertical adjustment of the headlight
beam is controlled by loosening the
headlight assembly mounting bolts
and altering the position of the
headlight assembly.
• Retighten the headlight assembly
mounting bolts after adjustment to
89 lbf in (10 Nm).
