Cleaning and Storage
164
Clean the windscreen with a solution of
mild soap or detergent and cold water.
After cleaning, rinse well and then dry
with a soft, lint-free cloth.
If the transparency of the windscreen is
reduced by scratches or oxidation which
cannot be removed, the windscreen
must be replaced.
Preparation for Storage
To prepare the motorcycle for storage,
do the following:
• Clean and dry the entire vehicle
thoroughly.
• Fill the fuel tank with the correct
grade of unleaded fuel and add a
fuel stabiliser (if available), following
the fuel stabiliser manufacturer's
instructions.
Warning
Petrol is extremely flammable and can
be explosive under certain conditions.
Turn the ignition switch off. Do not
smoke.
Make sure the area is well ventilated
and free from any source of flame or
sparks; this includes any appliance
with a pilot light.
• Remove the spark plug from each
cylinder and put several drops (5
ml) of engine oil into each cylinder.
Cover the spark plug holes with
a piece of cloth or rag. With the
engine stop switch in the RUN
position, push the starter button for
a few seconds to coat the cylinder
walls with oil. Install the spark plugs,
tightening to 12 Nm.
• Change the engine oil and filter (see
page 121).
• Check and if necessary correct the
tyre pressures.
Summary of Contents for Rocket 3 TFC 2020
