Triumph Daytona Moto2 765 2020, Owner'S Handbook Manual

Page: 135 / 163

Maintenance
135
Caution
Do not cover the headlight or lens
with any item likely to obstruct air
flow to, or prevent heat escaping from,
the headlight lens.
Covering the headlight lens during
operation with items of clothing,
luggage,
adhesive tape, devices
intended to alter or adjust the
headlight beam or non genuine
headlight lens covers will cause the
headlight lens to overheat and distort,
causing irreparable damage to the
headlight assembly.
Damage caused by overheating is not
considered a manufacturing defect
and will not be covered under
warranty.
If the headlight must be covered
during use - such as taping of the
headlight
lens required during
closed‑course conditions - the
headlight must be disconnected.
Headlight Adjustment
Note
Each headlight can be adjusted by
means of vertical and horizontal
adjustment screws located on the rear
of each headlight.
1 4 2 3
1. Horizontal adjustment screw (left hand)
2. Vertical adjustment screw (left hand)
3. Vertical adjustment screw (right hand)
4. Horizontal adjustment screw (right hand)
To adjust the headlight:
• Switch the headlight dipped beam
on.
• Turn the vertical adjustment screws
on each headlight clockwise to lower
the beam or anticlockwise to raise
the beam.
• On the right hand headlight turn the
horizontal
adjustment screw
clockwise to move the beam to the
right or anticlockwise to move the
beam to the left.
• On the left hand headlight turn the
horizontal
adjustment screw
clockwise to move the beam to the
left or anticlockwise to move the
beam to the right.
• Switch the headlights off when both
beam settings are satisfactorily set.