2 of 4
1.
Fit the spring retainer to the hole on the right hand
side of the frame, above the centre stand mounting
brackets as shown. Fit the M8 lock nut and tighten to
27 Nm
.
Note:
•
On California models, release and reposition the
evaporative canister to improve access.
1. Spring retainer
2.
Lubricate the flanged sleeves with the grease supplied
and fit them to the stand ensuring each sleeve is fitted
from the right hand side as shown below.
1. Flanged sleeves
2. Centre stand
3.
Align the centre stand to the mounting brackets on the
frame. Position the stand on the right hand side of the
brackets.
Warning
This accessory kit is designed for use on Triumph Scrambler
motorcycles only and should not be fitted to any other
Triumph model or to any other manufacturer’s motorcycle.
Fitting this accessory kit to any other Triumph model or to
any other manufacturer’s motorcycle, may interfere with the
rider and could affect the stability or other aspects of the
motorcycle’s operation which may result in loss of
motorcycle control and an accident.
Warning
Always have Triumph approved parts, accessories and
conversions fitted by a trained technician of an authorised
Triumph dealer. The fitment of parts, accessories and
conversions by a technician who is not of an authorised
Triumph dealer may affect the handling, stability or other
aspects of the motorcycle’s operation which may result in
loss of motorcycle control and an accident.
Warning
When fitting this accessory kit, ensure that the motorcycle
is stabilised and adequately supported to prevent risk of
injury from the motorcycle falling.
Warning
Failure to tighten any of the fasteners to the correct torque
specification may result in loss of motorcycle control and
an accident. Always use a calibrated torque wrench.
1
T908.CS.02
T908.CS.03
1
2
