© 2016 Escalade Sports
For Customer Service Call 1-888-996-2729
6
All Rights Reserved.
PARTS REQUIRED:
8 pcs -
H3
Phillips Round Head Screw
2 pcs -
P7
Goal Box with Sensors
STEP 3:
First, feed the sensor plug from each
P7
Goal Box with Sensors through each end apron and underneath table support
frames as shown in
FIGURE 3
and
UNDERNEATH TABLE DIAGRAM
. Guide the sensor wires following the path shown
with the arrows in
FIGURE 3
and
THE UNDERNEATH TABLE DIAGRAM
from the goal box to the junction box
Connect
P7
Goal Box with Sensors connectors to underneath
C3
Junction Box as shown in
FIGURE 3
.
Secure
P7
Goal Box with Sensors onto
P1
Air Hockey Cabinet using pilot holes with
H3
Phillips Round Head
Screws as shown in
FIGURE 3
.
Tighten, But do not strip out H3 Screws.
P7
H3
P1
P7
FIGURE 3
C3
Junction Box
(underneath table)
C1
DC Motor
(underneath table)
C2B
BLUE LED Corner Post
C2R
RED LED Corner Post
C2R
RED LED
Corner Post
UNDERNEATH TABLE
C1
DC Motor
GOAL BOX
GOAL BOX
C3
Junction Box
IMPORTANT NOTE:
Be sure to route the goal box sensor
wires thru the support beam cutouts
for correct assembly.
IMPORTANT NOTE:
As you attach the
P7
Goal Boxes,
make sure to very lightly pull any
excess wire thru the end apron that
may be blocking the electronic scoring
sensor eyes.
IMPORTANT NOTE:
the connectors that plug into the junction box
will only fit into their slots when turned correctly.
A flashlight may be helpful to achieve this
correct installation.
C2B
BLUE LED Corner Post
