Triumph 415T, User Manual

Page: 5 / 15

INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
TREADMILL OPERA
TION
LIMITED
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE YOU
BEGIN
TREADMILL OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
NOTE: During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before
completely tightening any ONE bolt.
NOTE: A light application of grease may aid in the installation of hardware. Any grease, such as lithium bike
grease is recommended.
PRE-ASSEMBLY ASSEMBLY STEP 2
ARC WASHER (C)
17 mm
Qty: 4
SPRING WASHER (B)
15.4 mm
Qty: 4 BOLT (E)
25 mm
Qty: 4
HARDWARE BAG 2 CONTENTS :
* NOTE: Be careful not to pinch any wires while assembling the masts.
BOLT (E)
SPRING WASHER (B)
ARC WASHER (C)
CONSOLE
CONSOLE MAST
ASSEMBLY STEP 1
WASHER (C)
15.5 mm
Qty: 4 ARC WASHER (D)
17 mm
Qty: 4
SPRING WASHER (B)
15.4 mm
Qty: 8 BOLT (A)
15 mm
Qty: 8
HARDWARE BAG 1 CONTENTS :
BOLT (A)
SPRING WASHER (B)
CONSOLE MAST
CONSOLE MAST
SUPPORT TUBE
BOLT (A)
CONSOLE WIRE
SPRING WASHER (B)
ARC WASHER (D)
FLAT WASHER (C)
Open HARDWARE BAG 1 .
Slide the right CONSOLE MAST down
on to the CONSOLE MAST SUPPORT
TUBE . On the front of the CONSOLE
MAST , bolt in place using 2 BOLTS
(A)
, 2
SPRING WASHERS (B)
, and 2
ARC WASHERS (D) . On the side of the
CONSOLE MAST , bolt in place using 2
BOLTS (A) , 2 SPRING WASHERS (B) ,
and 2 FLAT WASHERS (C) .
Repeat on other side.
On right side thread CONSOLE MAST
WIRE through CONSOLE MAST.
A
B
C
D
Open HARDWARE BAG 2 .
Attach the CONSOLE to the CONSOLE
MAST using 2 BOLTS (E) , 2 SPRING
WASHERS (B)
, and 2
ARC WASHERS
(C) .
Repeat on other side.
After all bolts are inserted for
ASSEMBLY STEP 1 and ASSEMBLY
STEP 2 , all bolts can be completely
tightened.
A
B
C
D
* NOTE: While assembling the masts, do not completely tighten any bolts until the end of ASSEMBLY STEP 2 .
Ensure that ALL bolts are in place and partially threaded in before completely tightening any ONE bolt.
415T_Rev.1.5.indd 8-9 5/13/08 4:07:21 PM