Features:
•
Low noise / low esr power supply
•
Switchable transfomer ratio / input impedance
•
Selectable all Fet or Tube-Fet circuit
•
Stepped attenuator
•
Lundahl 1571 input transformer
•
Low impedance jFet buffer with superb sonic properties
•
phase reverse switch
•
phantom power
Specifications:
•
Gain:
Tube-Fet mode: 60 dB
•
Gain
Fet mode: 70 dB
•
EIN:
-128dB
•
Headroom:
32 dB
•
Input impedance:
2,25KOhm / 6,25KOhm
•
Output impedance: 100Ohm
•
Power:
24V AC
•
input:
XLR
•
output:
XLR(pin 2 hot) + 1/4" TRS
How to connect D
2
O:
Power supply:
Input for the supplied 24VAC PSU.
Input:
XLR connects with signal source.
Output:
XLR or 1/4” TRS, connects with mixer, DAW or recorder.
How to use D
2
O:
To avoid unwanted noises please consider the following rules of use:
Switch off phantom power before disconneting the microphone.
Turn down the gain before switching on phantom power or changing the feedback
ratio switch position.
When connecting D
2
O to a channel/device with phantom power, make sure
phantom power is turned off on the recieving channel./device.
When using D
2
O's balanced output, add +6dB gain on the receiving channel when
this is not servo-symmetrical, this enables optimal headroom.
Finally, we wish you lots of fun and fruitfull recording sessions!
Team TritonAudio.
©TritonAudio 2013
