6
GB
Step 8
Check the alignment of the saw and make
any required adjustments as outlined in the
Workcentre or Slide Chassis instructions. Set
the saw to full depth and carry out some test
cuts.
Operation
With the saw set at full depth push-fit the
winder handle (C) through the saw slot and
into the hex hole on
the top of the winder
mechanism. If a dust
bag is fitted, punch a
hole through it using
the shaft of the winder
handle. Use the winder
handle to set the desired cut depth in the table
saw mode, as shown.
Remove it before
attempting any cuts. In
the crosscut mode, set
your cut depth using
the thumb-wheel, as
shown.
When not in use the
winder handle can
be stored by its clip
in the table height
adjustment slot on the
Workcentre end panel.
Assembly / Warranty
Triton Precision Power Tools guarantees
to the purchaser of this product that if
any part proves to be defective due to
faulty materials or workmanship within
12 MONTHS from the date of original
purchase, Triton will repair, or at its
discretion replace, the faulty part free of
charge.
This guarantee does not apply to
commercial use nor does it extend to
normal wear and tear or damage as a
result of accident, abuse or misuse.
* Register online within 30 days.
Terms & conditions apply.
This does not affect your statutory rights
To register your guarantee visit our web site at
www.tritontools.com* and enter your details.
Your details will be included on our mailing list
(unless indicated otherwise) for information on
future releases. Details provided will not
be made available to any third party.
PURCHASE RECORD
Date of Purchase: ___ / ___ / ____
Model: WCA390
Retain your receipt as proof of purchase
WARRANTY