Page 9 of 20
TRITTON IXC
|
P.O. Box 2235 Chino Hills, CA 91709
•
USA
W A T E R P U R I F I C A T I O N S Y S T E M
SERIES IXC-850
VI. PROGRAMMING THE EC-100 CONTROLLER
NAVIGATION AND PROGRAMMING MENU:
SET key, is access to settings mode.
UP key increases the setting values.
DOWN key decreases the setting values.
Main screen: Displays the operating status:
FLUSH (Activated)
- Purges at low pressure (
Valid on systems
with Fast Flush option
) Does not apply for model IXC - 850.
LOW
- Indicates that the system is protected by low pressure
and is off (
stand by
) until there is sufficient inlet pressure to
restore system operation.
FULL
-
Indicates that the system is in standby as the stop signal
was received by high product water level in the storage tank.
TIMER
-
The time the system has been in continuous operation.
The Timer on the screen changes under different cycles of time,
at the beginning it shows (minutes: seconds) and later when it
reaches one hour changes to (hour: minute).
When the system is in (Stand by), the display will show the total
accumulated time that has been operating after 9999 hr the timer
will start a new cycle starting from scratch again.
- At initial start-up, the system counts in seconds until it reaches
minutes and later to hours as in the example below.
By default the controller provides a 10 second delay in start-up
of the system when you place the selector switch in
AUTO
for
double electrical protection of the system.
TDS
- Registers the quality of the product water by measuring
the total dissolved solids in PPM units.
CONTROLLER PROGRAMMING:
The IXC-850 Reverse Osmosis System has already been factory
programmed with pre-set parameters for basic operation,
however if you want to adjust time setting for models pur-
chased with fast integrated flush, then follow these instructions
for adjustment:
1.
With the system pluged and selector switch in AUTO, press
and hold down the SET key for 3 seconds to enter the settings
mode until you hear a "Beep" then enter the options menu
to adjust the setting parameters. P1 starts with the UP and
DOWN keys to adjust the parameter as needed. Once com-
plete press the SET key again to pass to the next parameter
(P2) and so on until you make your adjustments up to P6
and then go back to the home screen.
CONTROLLER
EC-
100
00:00
TIMER
000
T.D.S
LOW
FULL
MAIN
PUMP
FLUSH
00:00
TIMER
000
T.D.S
LOW
FULL
MAIN
PUMP
FLUSH
IXC SYSTEMS DO NOT KEEP CONTINUOUS TIME
IF POWER IS LOST OR IF A LOW PRESSURE OR WATER
LEVEL ALERT IS INDICATED AND THE SYSTEM
IS SHUT-OFF.
00:59
TIMER
(
seconds
)
01:00
TIMER
(
minutes
)
01:10
TIMER
(
hours
)
IF POWER IS INTERRUPTED OR IF THE SYSTEM IS
SHUT-OFF BY A WARNING SWITCH. THE SYSTEM WILL
START FROM ZERO AGAIN.
Programming the EC-100 Controller
