Thermostatic bar mixer shower
10
COMMISSIONING
Start the water flow by rotating the flow control
(left hand side) anticlockwise.
Make sure that the hot and cold water supplies
are fully open and at (or near to) their design
temperature and pressures, and are within the
requirements as stated on
page 2.
Make sure the temperature control (right hand
side) is at the maximum temperature setting.
Allow the shower to run at this maximum
temperature setting until the water temperature
has stabilised.
Rotate the temperature control until your desired
maximum showering temperature is reached.
NOTE:
If your desired temperature is above
the maximum temperature stop limit, please
see
Adjusting The Maximum Temperature
Stop Settin
g
section.
A final temperature check
SHOULD
be made
on-site to guarantee user safety and that the
mixer falls within recommended maximum
mixed water outlet temperatures as stated in
the
Receommended Outlet Tempertaures
section.
