Washers
Shower
Showerhead
Showerhead
Holder
Slide the soap dish and hose retainer onto the
riser rail, below the showerhead holder
(fig.5)
.
Locate the riser rail assembly to the upper
bracket. Align the upper hole in the riser rail with
hole ‘A’ in the bracket and secure using one of
the long screws supplied
(fig.6)
.
Align the bottom hole in the riser rail with hole
‘A’ in the lower bracket and secure.
Fit the bracket trims over each end of the riser
rail, locating the runner into the groove before
sliding onto the bracket
(fig.7)
.
Push fit the rail end trims into each end of the
riser rail.
Fitting the hose And
showerheAd
Feed the flexible hose
(fig.8)
through the
retaining ring
(Water Regulations).
Screw the flexible hose to the shower outlet
and showerhead, making sure the supplied
washers are in place at both ends of the flexible
hose
(fig.9)
.
Place the showerhead into the holder and
check that it fits correctly
(fig.10)
.
Note:
The holder is slightly tapered and the
showerhead and hose will only fit from one
direction.
IMporTANT:
It is the conical end of the
hose which grips into the holder. The
showerhead will not fit in the holder without
the hose attached.
ANdrew rISer rAIL ASSeMBLY
Fig.5
Fig.8
Fig.9
Fig.10
A
Fig.7
Fig.6
