Gemini Profiler with Survey Software
0695-SOM-00009, Issue: 01
8
© Tritech International Ltd.
3. Configure the Gemini Software
To set the Gemini software for use with a survey computer running EIVA NaviScan
it will be necessary to configure the data output over an Ethernet port. The computer
running the Gemini software will essentially be connected to two LANs, one for the
Gemini Profiler head(s) and the other for the connection to the survey software.
Note
The computer running the Gemini software and the computer running
the NaviScan software should be assigned IP addresses within the same
subnetwork.
The network settings for the connection to NaviScan are located in the section titled
Set up network data output
in the
Digitisation
section of the
Advanced
tab (as shown in Figure 3.1, “Gemini Software Digitisation Settings”).
The
Format
should be set to
Tritech
and the
Hostname
set to the IP address of
the computer which is running NaviScan.
Figure 3.1. Gemini Software Digitisation Settings
Once the network has been properly set it will be necessary to configure the
Hub
Setup
so that the data from auxiliary sensors is passed through correctly.
In the
Hub Setup
tab ensure that the time synchronisation is set to
GPS
and the
network data output is
Framed
.
Figure 3.2. Gemini Software Hub Setup
