TriStar SZ-1915, Instruction Manual, Page: 4 / 40

4
1
8
6 7
11
12
9
2
3
4
2
10
5
instruction manual
vacuum cleaner
PaRTS LiST
1. Suction hole
2. Holes for attaching the shoulder strap
3. On/off switch
4. Handle
5. Release button for the dust cup
6. Dust cup
7. Dust cup filter
8. Cleaning brush
9. Crevice brush
10. Plug
11. Flexible hose
12. Shoulder strap
aSSEmbLy
Warning.
Always unplug from electrical outlet before opening the dust cup (6).
Note: Dust cup filter (7) must be used when operating the vacuum cleaner
1. Press the Release button (5) to open the dust cup (6) then pull out the dust
cup(6). Check if the filter (7) is placed after checking place the dust container
(6) back on the vacuum cleaner.
2. To attach the cleaning brush (8) or crevice brush (9) to the vacuum cleaner.
push brush into the suction hole (1).
3. To use the flexible hose (11), push the end of the hose into the suction hole (1),
then attach the desired brush (8 or 9) to the other end of the flexible hose (11).
How to operate your hand vacuum
1. Hold the vacuum cleaner firmly with your hand on the handle (4).
2. Push the On/Off Power switch (3) to “On” position.
3. Start vacuuming.
caution: The vacuum cleaner is a very powerful unit. Make sure that you hold it
firmly. Otherwise it can slip out of your hand and cause injury.
cHaNgiNg & cLEaNiNg THE DuST cuP FiLTER
Warning: Always unplug from the electrical outlet before opening the dust cup (6).
1. To open the dust cup (6), push button (5) and pull out the dust cup (6).
2. Pull out the dust cup filter (7).
3. Empty the dust from the dust cup filter (7)
4. Rinse the dust cup filter (7) in cold water, and then wait until it dries
completely before replacing it into the dust cup (6).
5. Place the dust cup filter(7) carefully into the dust cup (6).
6. Attach the dust cup (6) to the hand vacuum.
important:
Make sure that dust cup filter is completely dry before inserting
back in the vacuum cleaner.
TRoubLESHooTiNg guiDE
PRobLEm PoSSibLE REaSoN PoSSibLE SoLuTioN
HAND VACUUM WILL
NOT OPERATE
1. Power cord not firmly
plugged into outlet.
2. No power in wall
outlet
1. Plug unit firmly
2. Check fuse or breaker.
Replace fuse/reset
breaker
HAND VACUUM WILL
NOT PICK-UP OR
SUCTION POWER IS
WEAK
1. Dust cup filter is full.
2. Unit clogged.
3. Dust cup filter needs
cleaning.
1. Empty dust cup filter
2. Turn unit off and
unplug from wall
outlet, Remove dust
cup filter and check
for object(s) in air
dust and remove.
3. Clean or replace dust
cup filter.
DUST ESCAPING FROM
HAND VACUUM
1. Dust cup filter is full.
2. Dust cup filter is not
installed correctly
3. Puncture hole in dust
cup filter
1. Empty dust cup filter
2. Review dust cup filter
instruction.
3. Replace dust cup
filter.