8
eN
iNstructioN maNuaL
• For additional protection, we advise you to install a residual current
device (RCD) in the electrical circuit that supplies the bathroom his
electricity. This RCD must have a rated residual operating current no
higher than 30mA. Ask your installer for advice.
• This appliance is not intended for use by person (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning use of appliance by a person responsible for
their safety.
• Children should be supervised to ensure that they do not play with the
appliance.
• If the supply cord is damaged, it must be replaced by manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
• WARNING: Do not use this appliance near water. Do not use this
appliance near bathtubs, showers, basins or other vessels containing
water. If this appliances has fallen into the water do not under no
circumstances directly grab this appliances but first pull the plug from
the socket.
(*) Competent qualified electrician: after sales department of the producer
or importer or any person who is qualified, approved and competent to
perform this kind of repairs in order to avoid all danger. In any case you
should return the appliance to this electrician.
before the first use
• Take the appliance and accessories out the box. Remove the stickers,
protective foil or plastic from the device.
• Clean before use the appliance with a damp cloth.
• During first use there could be some smoke and a burning smell.
This happens because the appliance is new. It will disappear after
a few minutes. This does not mean there is a malfunction and it will
not cause one.
use
• Unwind the power cord.
• Put the plug of the curling iron into the socket and turn the switch to
the “ON” position.
• Wait a couple of minutes to allow the appliance to reach its working
temperature.
• Your hair should be dry or very nearly dry when using the curling iron.
Separate the strands of hair to be curled and gently brush it free of tangles.
• Grip the hair using the clamp and wind it towards the scalp.
Do not allow the barrel to come into contact with your skin because
this became very hot.
• Hold the curling iron in this position for around 10-20 seconds and then
gently unwind.
• Holding the curling iron in position for 5-10 seconds will create gentle
hair waves.
• Fine hair requires less time than coarse hair to create effects.
• To achieve extra bounce and body, lift several strands of hair and gently
run the brush through from scalp to the hair ends.
Summary of Contents for STYLED HD-2377
Page 2: ...2 ...
Page 39: ...39 ...
Page 40: ...HD 2377 Jules Verneweg 87 5015 BH Tilburg The Netherlands www tristar eu ...