TriStar Power AirFryer Pro TXG-KE10L, Owner'S Manual

Page: 9 / 24

Power AirFryer Pro™ | Model: TXG-KE10L
9
Using the Accessories
Rotisserie Spit Assembly
& Insertion
Rotisserie Shaft & Skewers Racks
1.
Place the two Skewer Racks at each end of
the Rotisserie Shaft. Make sure the Set Screws
are on the outer side of the Rotisserie Shaft (FIG. C).
2.
Slightly tighten Set Screws. Do not overtighten
as you may need to adjust the tightness after you
insert the Skewers.
3.
Carefully poke Skewers through food.
1.
Slide a Skewer into an open slot on the edge
of the Skewer Rack with the clip facing toward
the Rotisserie Shaft.
2.
Guide the sharp end of the Skewer through the hole
on the opposite Skewer Rack and push the clip
through the hole near the slot until the Skewer
is secure (FIG. D).
3.
Repeat steps 1–2 in a uniform manner around
the Skewer Rack. Make sure Skewers are evenly
spaced (FIG. E).
4. Tighten the Set Screws to make sure they are
securely in place.
5.
Use caution while inserting the Spit into the Unit
to prevent getting poked by the Skewer ends.
6. Open the door of the Unit. Slide the Rotisserie Spit
onto the rails in the center of the Unit.
7. Slide the switch on the left side of the Unit to the
right and hold the switch in place while pushing
the Rotisserie Spit as far back into the Unit as
possible (FIG. F).
8. Release the switch. The switch should slide
back into the left position, and the left side of the
Rotisserie Spit should be locked in place.
FIG. C
FIG. D
FIG. E
FIG. F