TriStar KB-7060UK Operation Instructions Manual Download Page 5

 

 

8

Never place hot food or drink in the appliance. 
Never keep flammable liquids and/or gases inside the refrigerator. Danger 
of explosion. 
 

 

Defrosting——Measures  to  be  taken  if  the  appliance  is  to  be  left 

unused for a long period. 

The refrigerator must be defrosted regularly, in order to ensure that it 
operates correctly. 
To defrost the refrigerator, disconnect it and remove all food outside. If 
necessary, use a cloth soaked with hot water. After de-icing, mop up the 
water with a dry clean cloth and clean the inside as described in paragraph 
13. 
If the appliance is to remain unused for a extensive period, disconnect it 
and remove all food outside. After de-icing, clean and dry the inside of the 
appliance. 
In order to prevent unpleasant odor, leave the cover of the refrigerator 
slightly open. 
 

 

Measures to be taken after unused for a long period 

If,  after  an  extensive  lay-up  period,  the  refrigerator  does  not  produce 
any cooling, disconnect the appliance and turn it upside down for a few 
minutes  then  turn  it  the  right  way  up.  After  turn  it  over  several  times, 
reconnect it. 

 

 

Maintenance 

Clean the appliance regularly with warm water, containing a detergent if 
necessary. Never use an abrasive product. Dry the cleaned surfaces with a 
soft cloth. Use only clear water to clean the seal of the cover, and then coat 
the seal with talcum powder. 
All repairs, particularly of the cooling unit or the gas burner system, must 
mandatorily be carried out by a qualified technician. 

 

 

9

 

 

 

Service 

If a problem occurs, carry out the following checks: 
- Is the appliance installed in a horizontal position? 
- Is there sufficient ventilation? 
- For 220V mains operation, check that the mains supply is correct. And is 
the thermostat set correctly? 
- For battery operation, check the battery and the connection. 
- For gas operation, is the burner ignited? 
- Has the ignition safety (adjustment) knob been set to MAX? 
- Are the gas cylinder valve and/or the pressure regulator open? 
- Is there still a sufficient quantity of gas in the cylinder? The cylinder is 
empty if no 
liquid can be heard moving about when it is shaken. 
- Have two modes of energy (gas and electricity) been selected at the 
same time? 
- Has too much food been placed inside the refrigerator all at once? 
Arrange the food so that the air is free to circulate inside the refrigerator. 
Do not use pieces cardboard or plastic as separations. Keep vessels 
containing liquids closed. 
 
If, despite the above checks, you still need to contact the service 
department, describe the failure and state the type of equipment and its 
serial number (these are marked on the lebel). 
If  the  power  cable  is  damaged,  it  must  be  maintained  by  the  original 
factory/  after-service  center  or  qualified  person  to  avoid  harmful 
substances. 

Summary of Contents for KB-7060UK







Reviews: