Tripp Lite NGI-M08C4-L2, Owner'S Manual

Page: 77 / 313

77
state is enabled, user must enable per VLAN states to enable the IGMP Snooping on the specific
VLAN.
6.2.1.1 General Settings
6.2.1.1.1 CLI Configuration
Node Command Description
enable show igmp-snooping This command displays the current IGMP
snooping configurations.
enable show igmp-snooping counters This command displays the current IGMP
snooping counters.
enable configure terminal This command changes the node to
configure node.
configure clear igmp-snooping counters This command clears all of the IGMP
snooping counters.
configure igmp-snooping (disable | enable) This command disables / enables the IGMP
snooping on the switch.
configure igmp-snooping report-
suppression (disable|enable)
This command disables / enables the IGMP
snooping report suppression function on the
switch.
configure igmp-snooping vlan VLANID This command enables the IGMP snooping
function on a VLAN or range of VLANs.
configure no igmp-snooping vlan VLANID This command disables the IGMP snooping
function on a VLAN or range of VLANs.
configure igmp-snooping unknown-
multicast (drop|flooding)
This command configures the process for
unknown multicast packets when the IGMP
snooping function is enabled.
drop : Drop all of the unknown multicast
packets.
flooding : Flooding the unknown multicast
packets to all ports.
Example:
L2SWITCH(config)# igmp-snooping enable
L2SWITCH(config)#
igmp-snooping vlan 1